Usage: This Cylinder Rebuild Seal Kit provides an easy and effective way to rebuild the cylinder on the log splitter, preventing oil leaks and other cylinder damage to extend the life of your log splitter cylinder If you have any problems, please contact us. - Type: Cylinder rebuild seal kit Seal Size: 4.0Bore x 1.75 Premium Material : Made of quality Rubber and Plastic for long service life. ) are the same size as your hydraulic cylinder before purchase. Hydraulic Jack Hydraulic Log Splitter Cylinder Rebuild Seal Replacement Kit Suitable For 4.5"Bore X 1.75" Rod Cylinder, By XSPANDER Log Sealer We will do our best to service you. Below is 4.5Bore x 1.75 rod cylinder Specification that OEM made by this seal kit: Retracted (center to center between rod mountain hole and clevis hole... To know whether it fits your cylinder, one good way is to disassemble and measure your cylinder to compare with each item specification. For more details, please refer to the image Thank you and have a good day Log Splitter Cylinder Kit There is O-ring inside. 5. Rod dust ring (Item 12): 44.5mm x 54mm 5.5mm /7.3mm, TPU Below is 4.0Bore x 1.75 rod cylinder Specification that factory made by this seal kit: Retracted (center to center between rod mountain hole and clevis hole: 32.4” Extended (center to center same as above): 56.4” Stroke: 24±0.05” Dimension from center of clevis hole to back face of cylinder: 2.95” Dimension from center of rod end hole to front face of rod: 1.06” Dimension from center of rod end hole to front face of cylinder: 1.18” Ports: 1/2 NPT Dimension from port to port: 25.4” Rod: 1.75 rod Rod end mountain hole: 0.55” Clevis Mountain hole: 1.16” Dimension between mountain clevis to clevis: 0.87” Thickness of each mountain clevis: 0.375” Length of each mounting clevis: 4.125” Seal Size: Bore (I.D.) 4.5 x rod (O.D) 1.75 Buy Jimen for Ford Bronco 2021-2023, for Ford Bronco Sport 2021-2023, 2PCS Tailgate Rear Window Heater Cable Cover Trim Please note some cylinder rod head OD size is not rod size. 2. Wear rings. Piston wear ring : 101.6 mm ( OD 4) x 95.25mm (ID 3.75) x 9.53mm (0.375 wide), Nylon Rod wear ring : 44.5mm (ID 1.752) x 50.8mm (OD 2”) x 9.53mm (0.375 wide), Nylon 3. Piston seals 1 square ring and 1 O-ring. Double check each seal groove is good for our part sitting in. 1. Cylinder tube Bore (I.D.) 4.0 x rod (O.D) 1.75.
