Step 3：Install the Center Pad Eyes. We recommend install pad eye 1/3 the distance from the rear and front of the kayak,make sure to angle the bottom of the pad eyes toward the center line of your boat that helps prevent the rope from sagging(Tilt angle about 45 degrees). This kit includes a heavy-duty line to ensure the stability and safety of the kayak or boat when parked. SUITABLE FOR: This kayak anchor trolley kit is suitable for marine kayak, canoe... The reflective rope is long enough to meet your using needs,Will not deform or break under severe weather and heavy-duty tasks,can use for a long time. South West Kayak Fishing: Anchor Trolley Set Up Capacity: 1000mAh, Voltage: 7.4V, Discharge Rate: 25C, Connector:Tamiya, Dimensions: 106x19x12mm, Weight: 51g Step 2：After install pad eyes,used the stainless steel karabiner to attach pulley to the pad eyes. Step 5：Trolley Line Installtion. Kayak Anchor Kayak Canoe Anchor Trolley Kit With 33ft Reflective Rope Trolley System Kit Anchor Trolley Kit With Zig Zag Cleatpulleyspad Eyessnap Hooksrigging O Ringand Mounting Hardware Boat Anchor Kit Step 4：Install the Zig Zag Cleat. 【Easy Installation and Use】kayak anchor trolley pulley is easy to install and disassemble,can be installed on the left or right side. Kayak canoe anchor trolley system suit for marine kayak, canoe, fishing boat, rubber dinghy etc. Strong nylon zig zag anchor cleat provides a stable access point to secure anchors, bow lines, and safety lines. The pulley blocks and snap hooks of anchor trolley system made of stainless steel,manufactured in strict process, anti-rust and wear resistance with strong structure. Make sure the cleat is within easy reach from seat position, usually best located behind the seat (rather than beside it) to minimize interference between the cleat and your paddle,the length of the screws used for the zig zag cleat is M5x30mm. the standard location for the pad eyes will be above the WATER LINE of the kayak, approximately 9-12 inches from the bow and stern. 【You Will Get】Kayak anchor trolley kit include:1 x 5mm diameter,33ft length reflective rope,1 x zig zag cleat,1 x rigging o ring,2 x stainless steel snap hooks,2 x pulleys,4 x nylon pad eyes,8 x M5x25mm screws,2 x M5x30mm screws,10 x M5 rubber nut. First, tie one of the loose cord ends directly to rigging O ring. 【Good Stability System】Kayak canoe boat anchor trolley kit is a piece of equipment that that is used to help a kayak owner control the positioning of their kayak when they are out on the water,can be installed on the kayak left or right side, using ropes and pulleys to help you move the kayak's position without pulling the anchor,not only can you stabilize your kayak or boat in all types of current,but you can also change your vessel's position on a whim.
 [frigokit.com]-1000x1000w.jpg)
