Since we typically use the JD-XI as a sound module, this setup was ideal to optimize our workflow. We also wanted to ensure that the synth would stay put while we twist and tweak the knobs so we could use it for live applications as well. NovoPro NovoPro SMS50R A pair of studio monitor desktop stands with... Note that due to the nature of 3D printing and filaments, there may be a slight variation in color from that shown in the image. Roland JD-Xi Interactive Analog/Digital Crossover Synthesizer CABLE KI – Kraft Music Pyle Portable Megaphone Bullhorn - Bluetooth Compatible PA Speaker with Built-in Voice Changer, 1500 Yard Range, Siren, 100W Adjustable Vol Control, Loudspeaker for Outdoor Sports & Safety Drills Placing the JD-XI at 50 degree angle turned out to be the best solution that provided easy access to all the knobs, dials and controls. This is by far the best solution we could come up with to secure the synth in place and prevent it from sliding around. Speaker Stand Monitor Mount Red Color Angled Mounting Stands For Roland Boutique SH-01A Analog Synthesizer These stands where designed to use the cutout sections on the rear of the synth as an anchor point. Note that due to the nature of 3D printing and filaments, there may be a slight variation in color from that shown in the image Due to the nature of the 3D printing process, there will be some layer lines or other manufacturing details present in the finish The listing image is a good representation of what you can an expect. We provided images showing the rear of the JD-XI with stands attached which you can use as a reference. Thick lugs on the stands index into these cutout sections which prevents the stands from moving side to side or up and down. This is a Made In The USA by THE ANALOG SOURCE 3D Printed 35 Degree Angled Mounting Stand - Note this is just a stand and does NOT include any synthesizer (FEATURES) This item is custom hand made in the USA, Manufacturing process: 3D Printing, Material: PLA, Color: Black, Only fits the Roland JDXI synthesizer, Does Not fit any other Roland products Provides approx 50 degree angled mounting location for your Roland JDXI, Designed by musicians for musicians ! Also note that due to the nature of the 3D printing process, there will be some layer lines or other manufacturing details present in the finish. For those of you who are heavy-handed when you play your synths, you can apply some velcro to the flat surface on the bottom of the stands where it sits on your studio desk. Custom Made in the USA by the THE ANALOG SOURCE 3d printed mounting stand
.jpg)
