We recommend but do not require, that parts are placed in an oven at 450ºF (232°C) for approximately 30 minutes. Metallic coatings will require 3 – 5 additional minutes following the flash phase. Fixture part(s) to allow for the best view and application access; this can be done by using support hooks and support wires. Adjust your gun’s settings to provide an adequate powder cloud that is not projecting too much powder but also not too little. Prismatic Powders Commercial & Industrial Coatings | Prismatic Powders... PRE-TREATMENT A sand-blasted profile is highly recommended for the substrate to remove any rust, scale, or other coatings. safety goggles and respirator. APPLICATION Confirm all ground connections are properly made before the application begins. Applying Prismatic Powder Anti-Gas Primer can assist with parts more prone to outgassing (ESS-11152). Powde Coating Supplies: Metallics • When the part(s) have been completely coated, place them in the oven for a final cure cycle. Plug/mask off any areas that you do not want to be coated. For most powder applications, we recommend 2 – 3 mils (0.002 – 0.003) per coat. This additional time helps to set the metallics in place. If contaminates are drawn to the surface during this phase, the affected areas will need to be addressed. 25-Ounce Red Jump Break Cue Stick Aska JB2, Break Cue. 14-mm Tip, Hard Rock Canadian Maple Shaft. Regular price $189 $189.95 CAD Improper masking on certain mechanical parts or mating surfaces may cause tolerance or functionality issues. Add additional coating if needed. As mentioned above, a true earth-ground connection is always considered as best practice. PLEASE REFER TO EACH POWDER’S TECHNICAL DATASHEET FOR SPECIFIC PRODUCT INFORMATION PREP Remove all coatings, oils, and contaminants from the substrate with either a chemical stripper or a degreasing agent (Acetone, Brake Parts Cleaner, or Simple Green); these are some examples of chemical strippers and degreasers that work well depending on the condition of the substrate. Cure schedules can be found on powder bag label. Nordson Powder Coating SILVER SPARKLE | PPB-4727 | Prismatic Powders Chrome Powder Coat This will aid in discharging part(s) that have developed any static charge and evaporate any surface moisture or solvents from degreasing. You will be looking to verify that the spray gun does not surge while the trigger is pulled. CURING If additional layers of powder are expected to be applied, it’s imperative to flash/partially cure each layer beforehand. Once the part(s) are cooled to room temperature, check mil thickness to see if additional coats are required.
