- Surface may be sanded or ground when cured. - No measurable shrinkage. Magic Sculp will adhere tenaciously to most any surface, and can be sanded and painted when hard. Water and soap clean up. - Easily mixed (Resin and Hardener slightly color coded: mix until one solid color). - Good adhesion to almost all clean surfaces, including glass. - Excellent malleability. Materials: Epoxy Putty | Costuming | Red Nebula Studios Surface may be smoothed out with water. Easily mixed, use equal parts of resin and hardener, mix until one solid color. One of the few epoxies that will smooth out with water. Features: - Magic Sculp will adhere tenaciously to most any surface, and can be sanded and painted when hard. Magic Sculpt grain structure is finer than any other product available and will not shrink or crack even when formed in large structures. Magic Sculp will set at room temperature in about 30 min and completely cure within 24 hours. Wide Application: These flower charms can be used to make earrings, bracelets, necklaces, pendants, anklets, ornaments , belts, keychain, jewelry DIY and DIY craft making, they are amazing decorations - Surface may be smoothed out with water. - Water and soap clean up. Ratio may be varied to slow or speed up time. Morezmore Experience: Not only Magic Sculp is great for building armatures and bases because of its superiour strength but it has fine enough grain to actually sculpt from it - see the 2 tall Firefly sculpture on the picture below. Magic Sculp will cure at room temperature. Magic Sculpt two part epoxy putty. 5 Lb (2.5 lb resin, 2.5 lb hardener, total of 5 lb) If gloves are not an option, wash your hands promptly after you finish working with Magic Sculp with soap and water. It can then be shaped, sculpted and smoothed with a wet finger or modeling tools. Magic Clay Magic Sculpt Epoxy Clay - 5lb White Green Stuff Completely inert when cured. Aazon.co: 00372-FS agic Sculpt TAN Epoxy Putty 1 lb Epoxy Clay... Magic Sculp (sometimes called Magic Sculpt) by Wesco Two-part Epoxy Putty Sculpting and Modeling Compound Manufacturer Info: Welcome to Magic Sculp - the two-part epoxy putty specifically designed to meet the needs of modelers, crafters and sculptors alike. Do not touch your face. - Repairs low pressure leaking pipes of plastic, cast iron, stainless steel, and copper. Its grain structure is finer than any other product available and will not shrink or crack even when formed in large structures. Very forgiving on mixing ratio. It will harden in 1 1/2 to 3 hours.
